CHAMELEON SAMPLER To Install Chameleon on a PC Running Windows: - Place disk in Drive a: - Go to Program Manager, click File, click Run - Type in a:\setup and press Enter. This will Install Chameleon To Configure Chameleon: - In the Chameleon Program Group, Double Click the "CUSTOM" icon. - Click on Interface and then ADD - Under Type, use the scroll down arrow to select PPP The first time you install the program the default file name is PPP0 - Go to Setup (you must select this menu for each of the following) Click IP Address and Enter 204.71.16.100 -`Use the tab key to separate the numbers where there are periods Subnet Mask should now be: 255.255.255.0 - Click on Subnet Mask and change this if it is not correct Do Not enter a Host Name - Click on Domain Name and enter: sover.net - Click on Port and be sure it shows: 8 bits, 1 stop bit, No parity - Select the correct modem speed (usually 19,200) Click Modem and select the modem type you have. - Verify the Init String matches your particular modem. - Use: AT&F if you are not sure. This sets the modem to factory defaults. Click on Dial and enter the correct phone number for your area - see the list below Click on Login and enter your Username (with a capital 'P' in front) - Enter your password exactly as shown (including proper case) - Startup command should remain BLANK - Go to Services Click on Domain Server and enter: 204.71.16.10 - use the tab to move between boxes, as before. - Go to File and click on Save The default filename is fine - Exit Custom Click File and Exit -------------------------------------------------------------------- IF YOU USE EUDORA FOR EMAIL (in the 'extras' directly on the Chameleon disk) Under Special: Choose Configuration - Set POP Account to: username@sover.net where 'username' is the name you chose for login Do NOT use the Capital 'P' here ! - Set Real Name to your own Real Name or Business Name